I'm trying to follow the instructions on https://wiki.ampr.org/wiki/Installing_ampr-ripd_on_a_Ubiquiti_EdgeRouter_or_EdgeRouter_X but I'm not getting it and I've reset back to the default settings.  I've got the router setup and working as a gateway with external IP of 75.158.135.117 which was given by DHCP from my ISP and is on eth0.  On eth1 is set as my internal network as 192.168.1.1/24.  I have two ethernet adapters on my computer.  One is going to eth1 on the router.  The other is on eth2 on the router which is currently not configured.  I was thinking eth2 would be my 44 net.  I have setup a DMZ so everything that comes in to eth0 goes to my computer (I have a lot of servers running on that machine so if you scan it you will get lots of hits.  Have fun until I lock it down).

I'm hitting a snag on the very first part of router prep.  Where it says to edit the WAN_LOCAL rule set.  Under which do I add these?  Under source NAT rule or destination NAT rule?

BTW I'm running ER3 Lite 1.10.11 on my router.  Once I figure out a few of these things I can take some snap shots of my setup to add to the wiki page to help future setups.