[44net] OpenWRT AMPRNet config

Hi, I’m following the instructions at the below link to use OpenWRT as a 44Net gateway. I’m confused about some of the instructions. What should <AMPRGW> be replace with in the route. This has me confused as well: “an interface instance for a new VLAN and bridge (the example above uses AMPRNET), add it to its own firewall zone using Input: Accept (if you wish for you AMPRLAN devices to reach the router), Output: Accept and Forward: Drop (or Reject). Assign an IP from your allocation to this interface, you will configure this IP on your devices as the Default Route/Gateway address.” I created the AMPRNET interface but i put the 44Net allocation ip in the gateway of that interface, reboot after doing everything else, I get an error from Ampr-ripd that the interface doesn’t exist. If anyone has done this on a OpenWRT router, would you be willing to share your firewall and network config files so that I can learn what I’m doing wrong. http://wiki.ampr.org/wiki/Setting_up_a_gateway_on_OpenWRT Thanks Roger VA7LBB