9 Jan
2014
9 Jan
'14
4:48 p.m.
you use the pitnc_setparams utility.....
http://www.tnc-x.com/params.zip
on my older 256m without the mounting holes the syntax for txdelay is:
pitnc_setparams 0 0 1 40
newer board uses different address:
pitnc_setparams 0 1 1 40
to use the potentiometer, set txdelay to 0...
I've found that I've had to power down and re-power the pi to accept any
changes to txd...that's not in the manual, hi hi!
On 14-01-09 06:30 PM, Bill Vodall wrote:
(Please trim inclusions from previous messages)
_______________________________________________
I've just completed the pi-tnc and fired it
up with my pi using jnos. It
worked first time, but txd is way too short as I'm going through a mountain
top digital repeater. Everything is configured for a kissmode tnc for use
with jnos.
.. how to get out of the software preset so I can use R6 to set txd.
Does the
JNOS PARAM statement work? That's what we used in the past
with the other KISS TNC's.
Bill, WA7NWP
PS. Does your repeater reach South? I know of one existing 1200
baud packet repeater just North of Seattle but I don't think they have
any IP activity there (yet...)
_________________________________________
44Net mailing list
44Net(a)hamradio.ucsd.edu
http://hamradio.ucsd.edu/mailman/listinfo/44net