28 Sep
2022
28 Sep
'22
2:24 p.m.
Hey Chris, Marius,
Ok, thank you for the correction though I clearly remember that
"something" additional was required before RIP updates would start
flowing over the IPIP tunnel other than the user just defining their
gateway IP address for the IPIP tunnel endpoint. What is "that".
--David
KI6ZHD
On 09/27/2022 11:27 PM, Chris Smith via 44net wrote:
Marius is correct, the DNS entry is only required in
order for your
packets to be passed out to the internet and back. Without a DNS entry
you can happily exchange traffic within the IPIP mesh, but the gateway
machine will block any attempt to forward packets to/from the internet
if the 44..x.x.x IP involved does not have a (matching) forward &
reverse DNS entry.
73,
Chris - G1FEF
On 28 Sep 2022, at 01:09, Marius Petrescu via
44net
<44net(a)mailman.ampr.org <mailto:44net@mailman.ampr.org>> wrote:
I do not think that a DNS entry for the gateway is needed to receive
the RIP updates. If you register your gateway and assign a subnet to
it, you get the data via the IPIP tunnel from amprgw.
At least it was that way at some point. Maybe Chris could clarify this.
To my understanding, the only moment you need those DNS entries is if
your hosts need to pass traffic through amprgw to the internet and
back, and only affects the routing/firewall part at amprgw.
An "official" statement on this topic would be useful.
Marius, YO2LOJ
On 28/09/2022 02:15, David Ranch via 44net wrote:
_______________________________________________
44net mailing list -- 44net(a)mailman.ampr.org
To unsubscribe send an email to 44net-leave(a)mailman.ampr.org
Hello Harold,
The ampr-ripd traffic does go over port 520 but within the IPIP
tunnel itself (IP protocol 4). To receive ampr-ripd traffic, you
must have a DNS entry assigned to one of your AMPR IPs. FInally,
have you been able to confirm if your ISP allows/forwards IP
protocol 4 (IPIP)?
--David
KI6ZHD
On 09/27/2022 02:02 PM, Harold via 44net wrote:
_______________________________________________
44net mailing list -- 44net(a)mailman.ampr.org
<mailto:44net@mailman.ampr.org>
To unsubscribe send an email to 44net-leave(a)mailman.ampr.org
<mailto:44net-leave@mailman.ampr.org> Hey gang. Kinda new here for Ive been dabbling
with this for a few years though. I have been trying to use the ampr-ripd daemon without
any luck and have come to the conclusion that my ISP blocks port 520 which I believe is
the port used.
With that said, i have also come to the conclusion that at this time, the encap.txt file
is still accessible via ftp from theportal.ampr.org <http://portal.ampr.org>.
Is "wgetftp://USER:PASSWORD@portal.ampr.org/encap.txt" a valid ftp solution and
if so where is the USER:PASSWORD derived from?
Is it our user:password into the portal?
Thanks all
Harold K7ILO
_______________________________________________
44net mailing list --44net(a)mailman.ampr.org
To unsubscribe send an email to44net-leave(a)mailman.ampr.org
_______________________________________________
44net mailing list --44net(a)mailman.ampr.org
To unsubscribe send an email to44net-leave(a)mailman.ampr.org