[44net] cant get rip in MicroTik

I tried to follows the instructions that written here http://www.yo2loj.ro/hamprojects/ampr-gw-README.txt www.yo2loj.ro<http://www.yo2loj.ro/hamprojects/ampr-gw-README.txt> www.yo2loj.ro Setup example - please adapt ===== (ASSUMPTIONS: public ip is 89.122.215.236, router's ampr ip 44.182.21.254, WAN interface is PPPoE-In): You ... I have a working tunnel on the router called UCSD (the tunnel interface have no IP adress) my router is in bridge mode because it connect to cable modem before of it and sit on a DMZ address of the cable modem It uses ether1-gateway interface as the 44 net address (4.138.1.1) it uses ether2-master-local as the ip connected to the Cable modem (it uses 192.168.1.180 and default gateway to the cable modem ip which is 192.168.1.1) I have no firewall working and i get no RIP routes I have changed the tunnel interface name in the instructions to meet my interface name .. on the VRF if i chose the tunnel interface the routes (or maybe the tunnel) stop and i cant access anymore the 44 net hosts from the outside world and i see no rip info when i change the interface to the ether1-gateways (the one that have the 44 net address) the routes are ok the hosts are accessible from the outside world but i still not seeing any rip info what is wrong ? how can I debug it ? if needed i can provide password to the router since it is accessible from the outside world Thanks Forward Ronen - 4Z4ZQ http://www.ronen.org Ronen Pinchooks (4Z4ZQ) WebSite<http://www.ronen.org/> www.ronen.org ronen.org (Ronen Pinchooks (4Z4ZQ) WebSite) is hosted by domainavenue.com