13 Dec
2017
13 Dec
'17
7:07 a.m.
I have a message on debug output :
(total 648 entries).
RIP len 504 header version 2, Command 2 (Response)
Simple password: pLaInTeXtpAsSwD
Simple password authentication successful.
Is the password "pLaInTeXtpAsSwD" ? :)
Still no access to my gateway from internet (44.176.200.1)
Baris
----- Original Message -----
From: "Barış DİNÇ" <ta7w(a)antrak.org.tr>
To: "44Net" <44net(a)mailman.ampr.org>
Sent: Wednesday, December 13, 2017 3:04:40 PM
Subject: Re: [44net] GW Setup Problem
Thanks.. After filling an encap.txt file and placing it under /var/www/ampr-ripd I
started getting some more messages....
Now I have a full ip route table including 44.0.0.1
# ip route |grep 44.0.0.1
44.0.0.1 via 169.228.34.84 dev tunl0 proto 44 onlink window 840
And also when I do a tracepath now I directly go to desired target...
# tracepath 44.132.128.1
1?: [LOCALHOST] pmtu 1480
1: 44.176.200.1 (44.176.200.1) 0.099ms pmtu 1472
1: 44.132.128.1 (44.132.128.1) 47.047ms reached
Resume: pmtu 1472 hops 1 back 1
Still I don't use a password.. I should figure out how to gether my password....
When I do a tracepath to 44.176.200.1 from another internet machine I cannot reach my
gateway :(
TA7W on progress...
baris
----- Original Message -----
From: SP2L(a)wp.pl
To: "44Net" <44net(a)mailman.ampr.org>
Sent: Wednesday, December 13, 2017 1:49:01 PM
Subject: Re: [44net] GW Setup Problem
Baris.
You should see something like below:
root@linux:/# ampr-ripd -d -v -i tunl0
Using metric 0 for routes.
Using TCP window 840 for routes.
Using gateway 192.168.0.1 for direct 44net endpoints via interface eth0.
Waiting for RIPv2 broadcasts...
ampr-ripd -d -v -i tunl0
Simple password: <password>
Simple password: <password>
Simple password: <password>
Simple password: <password>
Simple password: <password>
Simple password: <password>
Simple password: <password>
Simple password: <password>
Simple password: <password>
Simple password: <password>
Simple password: <password>
Simple password: <password>
Simple password: <password>
Simple password: <password>
Simple password: <password>
Simple password: <password>
Simple password: <password>
Simple password: <password>
RipV2 broadcasts take place every 5 minutes starting fom full hour.
So, no need to wait 2 hours.
Also, check ip route; you should have something like that:
root@linux:/# ip route |grep 44.0.0.1
44.0.0.1 via 169.228.34.84 dev tunl0 proto 44 onlink window 840
root@linux:/#
Best regards.
_________________________________________
44Net mailing list
44Net(a)mailman.ampr.org
https://mailman.ampr.org/mailman/listinfo/44net
_________________________________________
44Net mailing list
44Net(a)mailman.ampr.org
https://mailman.ampr.org/mailman/listinfo/44net