I'd think about what Brian wrote about using a Raspberry Pi.
But if you must; you can look at this script by Antonio, AH6BW & Jason, KY9J that generates router tunnel configurations. Be aware that the UCSD address is now: 169.228.38.84
https://www.qsl.net/kb9mwr/wapr/tcpip/amprroutes.pl.txt
Steve, KB9MWR
On Thu, Jan 3, 2019 at 5:13 PM David Pechon via 44Net 44net@mailman.ampr.org wrote:
I am trying to setup a Cisco 2921/K9 router. The router has 3 gigabit ethernet ports and a CISCO EHWIC-4ESG 4-Port Gigabit WAN Interface Cardhttps://www.ebay.com/itm/CISCO-EHWIC-4ESG-4-Port-Gigabit-WAN-Interface-Card/323627581322?ssPageName=STRK%3AMEBIDX%3AIT&_trksid=p2057872.m2749.l2649. I can not get a static IP address from Spectrum so I need to set up a tunnel. Does anyone has have any dealing with this type of setup. I am looking for a way to where to start from. 73's
David A. Pechon Sr. KA5TTZ U.S. Army Retired (SSG/SS) Cell # (985)520-1748 HAMSHACK HOTLINE #4525
44Net mailing list 44Net@mailman.ampr.org https://mailman.ampr.org/mailman/listinfo/44net