David;
On Thu, 2019-01-03 at 23:09 +0000, David Pechon via 44Net wrote:
I am trying to setup a Cisco 2921/K9 router. The router has 3 gigabit ethernet ports and a CISCO EHWIC-4ESG 4-Port Gigabit WAN Interface Cardhttps://www.ebay.com/itm/CISCO-EHWIC-4ESG-4-Port-Gigabit-WAN-Interface-Card/323627581322?ssPageName=STRK%3AMEBIDX%3AIT&_trksid=p2057872.m2749.l2649. I can not get a static IP address from Spectrum so I need to set up a tunnel. Does anyone has have any dealing with this type of setup. I am looking for a way to where to start from. 73's
Here's what you *may* want to consider:
- 44-net IP mappings change very frequently and it's very difficult to keep an eye on which ones do - you don't have a static IP - no-ip services will help keep you linked easier - consider a Pi for a post router to your Cisco
When I had a T1 line back in the day, I had a 2600 series router off my smartjack. While I had a 44-net IP and ran IPIP, it didn't "route" for me. My xNOS was my 44-net router at the time as it was anyway so I set my 2600 up as a node off of xNOS. I didn't have to worry about hourly route changes on 44/8 or anything else. NOS handled all that for me at the time - and there was no portal back then.
You may want to consider something like an RPi unit to act as your 44/8 post router system and use it as I did xNOS back then. The ram in your cisco will remain a LOT cleaner as well. The RPi can also handle a dyndns software to keep your IP updated in the portal.