Re: [44net] Mikrotik hAP ac lite gateway configuration

Greetings all. I am trying to set up a gateway on the MikroTik hAP lite following the posted instructions at http://wiki.ampr.org/wiki/Setting_up_a_gateway_on_MikroTik_Routers. A few questions as I do not seem to be having success. At the end, prior to installing scripts, I do have access to the broader Internet however still have a 192.168.88.x address issued to my PC. Question on step 1: At first assign 44 Net address to your router Interface You do it by the web : IP --> Addresses --> Add New , a new screen will open , fill your 44 Net IP 44.xxx.YYY.ZZZ/your sub net (usually it will be /24) feel the network it should usually be same as the IP but with 0 in the end In the first I am using my 44 IP of 44.18.50.1/28 and then using the 44.18.50.0 in the network slot. Is that correct? I then assigned this to one of the LAN ports on the MikroTik which looks correct for the LAN IP info as it does change this from the 192.168.88.x sequence. The checkbox below that still shows as NAT, should this change to DHCP? Now some routes commands needed to be done 1) Route all the traffic to the tunnel interface You do it by : IP --> Routes and clicking on the 0.0.0.0 line and changing the gateway to the tunnel interface name and clicking apply The command line in text is as follow If I use the /ip route add distance=1 gateway=UCSD It creates a new entry showing UCSD however it does not connect. Am I doing something wrong in this whole process? After creating the tunnel the following instruction does not yield an editable gateway box as it would lead me to think it would so I cannot select the UCSD gateway. I did also load the scripts linked at the bottom of the page with edited IP addresses relevant to my networks and so not see the routes table updating. Any assistance would be appreciated. Thank you, Keith – AI6BX Sent from my iPad