Paul,
It seems you have registered the your GW with a dynamic address, so check that the GW address is the correct one (at this time 169.1.17.8).
After an IP change, it may take some time for ther ampr gateway to update its destinations. Also make sure you have your firewall set to accept protocol 4 (on the input chain).
But don't expect to much traffic on the ucsd interface other than the broadcasts every 5 minutes, at least at the beginning.
Marius, YO2LOJ
On 15.11.2019 21:27, Paul Greeff via 44Net wrote:
Hi OM
I'm hoping to pick someone's brain with regards to the IPIP and RIP config for AMPRnet on my Mikrotik at home.
I'm using the guide http://www.yo2loj.ro/hamprojects/ampr-gw-README.txt, which indicates after step seven and a few minutes of waiting I should see my routing table populated with routes with a 44rip routing mark. Nope.
I've monitored for port 520 on the IPIP as well as Internet facing interface and see no activity. I also haven't seen a single packet on the ucsd-gw interface (not sure if I should at this time). So I'm obviously missing something important and perhaps fundamental in this configuration.
Please send some of your wisdom my way.
Regards Paul (ZS6IO)