Hi Jonathan...i tried to get to you from 44.56.53.3 and it fails....
C:\Users\leonz>tracert 44.133.233.8
Tracing route to 44.133.233.8 over a maximum of 30 hops
1 <1 ms <1 ms <1 ms t30.wa4zlw.homedns.org [10.195.10.3] 2 1 ms <1 ms 1 ms core100.wa4zlw.ampr.org [44.56.53.1] 3 * * * Request timed out. 4 * * * Request timed out. 5 ^C C:\Users\leonz>
73 leon
On 7/18/2017 9:47 AM, Jonathan Gonzalez [EA1HET] wrote:
Hi Marc,
I don’t think there’s a minimal spec you should abide to in order to to put to work Net 44 on your site.
In my case, where we run a BGP session with Internet and publish our assigned segment, we use a CCR1036 having in memory the full BGP routing table, but even so, this is not a compulsory requirement for you.
In example, you can configure a less expensive router with only a default gateway to your ISP and/or to the ISP that runs the BGP session for you (if that would be the case). Our network design follows as a mere example of use (in ASCII art due to list restrictions):
_( )_( )_ ( ) x.x.x.x/30 ( ) _( )_( )_(_) ( )_ (_INTERNET_)—( X ) -------------- ( X )-(_44.133.233.0/24 _) (_) (__) ( ) ( ) (_) (__) (__) (_) BGP Local bridged router router w/ firewall
Both routers above are Mikrotik CCR1036 (CCR1036-8G-2S+EM) as mentioned before. If you want to launch a traceroute from public Internet, just to demonstrate above setup, you can use 44.133.233.8.
radio.ucsd.edu/mailman/listinfo/44net
--- This email has been checked for viruses by AVG. http://www.avg.com