Re: [44net] Tunnel on Cisco Router

On 1/18/17 2:45 PM, Bill Atkinson wrote:

I have a /22 block of AMPRNet space. I've configured it for tunnel access, and defined the gateway in my portal. Following the instructions on the wiki, here is my router config:

You'd need to setup ipip tunnels for all the known destinations in the AMPRnet space. the version of rip supported by amprnet is different from normal rip too, so the cisco will not support it.

If you have a /22 perhaps you can route it direct and get away from the IPIP encap mess that is amprnet? The guys in seattle will announce it via BGP and then tunnel it back to your router directly.

This might be the better option.