Hi Chris,
Did you register your IP in DNS? You need an A record for your IP address (any IP addresses you are routing) in order for it to pass the UCSD gateway out to the internet.
You can do this by asking your local coordinator or by asking myself.
73, Chris - G1FEF
On 12 Mar 2022, at 19:06, C B via 44Net 44net@mailman.ampr.org wrote:
HI After receiving my ip address assignment i am trying to set 44net up on my edgerouter 8. Following the instructions for the edgerouter on the wiki, and changing the port from eth2 to eth7 i as unable to ping thru to the internet as described in the instructions. An edge router 4 was also set up using the wiki instructions and the same result of not being able to ping thru to 8.8.8.8 on the edgerouter 4, thus i am continuing with the edgerouter 8 as this would be my final configuration. From the CLI "show interfaces tunnel tun0" the response shows traffic in both directions thus the tunnel appears to be up. In order to test my configuration, a edge router 4 was programmed to simulate the UCSD end of the tunnel and a Layer 3 switch was used to simulate the internet connection. The test setup as able to pass the IPIP traffic between the routers as expected, this leads me to believe i may have the setup correct or at least very close. now i am at a loss of how to troubleshoot further. Any advice, tips, troubleshooting methods, or help of any kind is greatly appreciated. Thank you Chris
44Net mailing list 44Net@mailman.ampr.org https://mailman.ampr.org/mailman/listinfo/44net