15 Nov
2019
15 Nov
'19
3:29 p.m.
Thank you Marius
The A record for the registered host is for a static IP address, so it will
not change.
I was expecting RIP updates according to the guide, but perhaps it is
something I should wait for. I.e., not the five minute update in the guide?
Regards
Paul
On Fri, Nov 15, 2019 at 10:17 PM Marius Petrescu via 44Net <
44net(a)mailman.ampr.org> wrote:
Paul,
It seems you have registered the your GW with a dynamic address, so
check that the GW address is the correct one (at this time 169.1.17.8).
After an IP change, it may take some time for ther ampr gateway to
update its destinations.
Also make sure you have your firewall set to accept protocol 4 (on the
input chain).
But don't expect to much traffic on the ucsd interface other than the
broadcasts every 5 minutes, at least at the beginning.
Marius, YO2LOJ
On 15.11.2019 21:27, Paul Greeff via 44Net wrote:
--
Paul Greeff
email(a)paulgreeff.com
Office: +27 86 100 3117
Cell: +27 83 954 3453
Fax:
086 659 0511
Winlink:
zs6io(a)winlink.org
Hi OM
I'm hoping to pick someone's brain with regards to the IPIP and RIP
config
for AMPRnet on my Mikrotik at home.
I'm using the guide http://www.yo2loj.ro/hamprojects/ampr-gw-README.txt,
which indicates after step seven and a few minutes of waiting I should
see
my routing table populated with routes with a
44rip routing mark. Nope.
I've monitored for port 520 on the IPIP as well as Internet facing
interface and see no activity. I also haven't seen a single packet on the
ucsd-gw interface (not sure if I should at this time). So I'm obviously
missing something important and perhaps fundamental in this
configuration.
Please send some of your wisdom my way.
Regards
Paul (ZS6IO)
_________________________________________
44Net mailing list
44Net(a)mailman.ampr.org
https://mailman.ampr.org/mailman/listinfo/44net