IPIP and RIP configuration on a Mikrotik - 44net

16 Nov 2019

That guide worked for establishing the tunnel, but I don't seem to get
working RIP packets.

The IP address for my local port is 44.x.y.1/32 with a network of 44.x.y.0
(/24). But the IP address on the tunnel interface is 44.x.y.2/32 with a
network of 44.0.0.0 (/8). Somehow this works and the tunnel connects.

Every five minutes I see some packets come in and a packet capture shows
the clear text password in them. But the RIP listener isn't seeing them. I
even set the RIP to listen for any advertisement (not just 44.0.0.0) on any
interface.

tg.
AJ4UQ.

On Fri, Nov 15, 2019 at 2:28 PM Paul Greeff via 44Net <
44net(a)mailman.ampr.org&gt; wrote:

...
  Hi OM

 I'm hoping to pick someone's brain with regards to the IPIP and RIP config
 for AMPRnet on my Mikrotik at home.

 I'm using the guide http://www.yo2loj.ro/hamprojects/ampr-gw-README.txt,
 which indicates after step seven and a few minutes of waiting I should see
 my routing table populated with routes with a 44rip routing mark. Nope.

 I've monitored for port 520 on the IPIP as well as Internet facing
 interface and see no activity. I also haven't seen a single packet on the
 ucsd-gw interface (not sure if I should at this time).  So I'm obviously
 missing something important and perhaps fundamental in this configuration.

 Please send some of your wisdom my way.

 Regards
 Paul (ZS6IO)
 --
 Paul Greeff
 email(a)paulgreeff.com
 Office: +27 86 100 3117
 Cell: +27 83 954 3453
 Fax:
 086 659 0511
 Winlink:
 zs6io(a)winlink.org
 _________________________________________
 44Net mailing list
 44Net(a)mailman.ampr.org
 https://mailman.ampr.org/mailman/listinfo/44net