Hey all, I am new to the 44 net stuff and had a couple basic questions. I went to the archive site and didn't see a search feature so I figured I would start here.
I've got my block allocated and am trying to setup my Juniper SRX firewall to tunnel to the 44 net.
However, I can't seem to find a place where the tunnel destination address is listed or if there is anything special I need to do on the AMPR site to activate traffic tunneling.
I'd be happy to share the config of my Juniper SRX with the community once I get it working.
Thanks
Craig Brauckmiller KC1ETB
On Mon, May 15, 2017 at 10:20 AM, Craig Brauckmiller kc1etb@gmail.com wrote:
Hey all, I am new to the 44 net stuff and had a couple basic questions. I went to the archive site and didn't see a search feature so I figured I would start here.
I am not an expert here but I will do my best.
I've got my block allocated and am trying to setup my Juniper SRX firewall to tunnel to the 44 net.
However, I can't seem to find a place where the tunnel destination address is listed or if there is anything special I need to do on the AMPR site to activate traffic tunneling.
amprgw.sysnet.ucsd.edu has address 169.228.66.251
Register your gateway here: https://portal.ampr.org/gateways_manage.php?a=addGateway
Also, each address on your subnet you would like to be able to tunnel to the internet must have an associated DNS entry on the AMPR nameservers. You can contact your region coordinator to add DNS entries.
I'd be happy to share the config of my Juniper SRX with the community once I get it working.
I sure others would appreciate this! Write to chris@g1fef.co.uk to get a wiki login set up for you and then you can add it to the wiki.
http://wiki.ampr.org/wiki/Main_Page
Tom KD7LXL
-
Craig Brauckmiller -
Tom Hayward