Good evening/morning folks!
I have some dumb questions about setting up the MicroTik. I currently have everything set(I got all the RIP records and routes created), however, it can't talk to the internet. I'm trying to figure out, would this be a firewall issue? Do I need to create a whole new NIC just for the 44net?
Basically, where should I go from here?
Thanks, Miguel Rodriguez 12th Grade Student miguemely101@gmail.com javascript:_e(%7B%7D,'cvml','miguemely101@gmail.com'); Tel: *561-758-0631*
*Accredited District Since 2008; Re-certification - January 2013*
Home of Florida's first LEED Gold Certified School
*Disclaimer*: Under Florida law, e-mail addresses are *public records*. If you do not want your e-mail address released in response to a public records request, do not send electronic mail to this entity. Instead, contact this office by phone or in writing.
Miguel,
You may wish to verify your IP allocation is properly configured and issued in the Portal.
Also, you must permit IPENCAP (IP Protocol No 4) to enter your wan interface.
What's your callsign?
73,
- Lynwood KB3VWG
My callsign is KM4VYU.
IPENCAP(ip4) being IPIP on the firewall?
I might have to explain a bit better at how my network works. I have two routers in this order: WAN-PFSENSE-MICROTIK
I know it's not the best setup, but I'm waiting to get more money to get a ERx.
Thanks,
Sent from my iPhone
On Sep 26, 2016, at 2:55 AM, lleachii--- via 44Net 44net@hamradio.ucsd.edu wrote:
(Please trim inclusions from previous messages) _______________________________________________ Miguel,
You may wish to verify your IP allocation is properly configured and issued in the Portal.
Also, you must permit IPENCAP (IP Protocol No 4) to enter your wan interface.
What's your callsign?
73,
- Lynwood
KB3VWG _________________________________________ 44Net mailing list 44Net@hamradio.ucsd.edu http://hamradio.ucsd.edu/mailman/listinfo/44net
On Sun, Sep 25, 2016 at 10:42 PM, Miguel Rodriguez miguemely101@gmail.com wrote:
(Please trim inclusions from previous messages) _______________________________________________ Good evening/morning folks!
I have some dumb questions about setting up the MicroTik. I currently have everything set(I got all the RIP records and routes created), however, it can't talk to the internet. I'm trying to figure out, would this be a firewall issue? Do I need to create a whole new NIC just for the 44net?
Basically, where should I go from here?
Have you requested DNS A and PTR records for each address you want to use on the internet? This is required before AMPR-GW will pass traffic.
Tom KD7LXL
I was not aware of this. Must have missed something somewhere.
Where would I do this request?
On Mon, Sep 26, 2016 at 2:11 PM, Tom Hayward esarfl@gmail.com wrote:
(Please trim inclusions from previous messages) _______________________________________________ On Sun, Sep 25, 2016 at 10:42 PM, Miguel Rodriguez miguemely101@gmail.com wrote:
(Please trim inclusions from previous messages) _______________________________________________ Good evening/morning folks!
I have some dumb questions about setting up the MicroTik. I currently
have
everything set(I got all the RIP records and routes created), however, it can't talk to the internet. I'm trying to figure out, would this be a firewall issue? Do I need to create a whole new NIC just for the 44net?
Basically, where should I go from here?
Have you requested DNS A and PTR records for each address you want to use on the internet? This is required before AMPR-GW will pass traffic.
Tom KD7LXL _________________________________________ 44Net mailing list 44Net@hamradio.ucsd.edu http://hamradio.ucsd.edu/mailman/listinfo/44net
-
lleachii＠aol.com -
Miguel R -
Miguel Rodriguez
-
Tom Hayward