POL: Potrzebuje pomocy. Jak modem podłączę pod ttyS0 (iobase 3f8 irq 4) na płycie głównej modem działa idealnie nadaje i odbiera. A jak podłączę go do ttyS1 (iobase 2400 irq 177) na karcie I/O to tylko odbiera nie chce nadawać ENG: I need help. How do I plug the modem into ttyS0 (iobase 3f8 irq 4) on the main board modem works perfectly transmits and receives. And when I connect it to ttyS1 (iobase 2400 irq 177) on the I/O just does not want to give answers ------ POL: Mam komputer z 2 modemami Baycom Linux CentOS 5, Kernel 2.6.18-274.18.1.el5ax25.2, używam sterownik: baycom_ser_fdx ENG: I have a computer with two modems Baycom Linux CentOS 5 Kernel 2.6.18-274.18.1.el5ax25.2, I use the driver: baycom_ser_fdx ------ POL: Używam modemów Baycom, podłączone do karty I/O PCI Modemy tylko odbierają (Rx) ale nie nadają (not Tx) ENG: I use Baycom modems, connected to the I/O PCI Modems only receive (Rx), but does not transmit (Tx not) ------ POL: A to konfiguracja karty I/O z komendy: lspci -vvv ENG: And this is the configuration I/O card with the command: lspci-vvv
Serial controller: Device 4348:3253 (rev 10) (prog-if 02 [16550]) Subsystem: Device 4348:3253 Control: I/O+ Mem- BusMaster- SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B- DisINTx- Status: Cap- 66MHz- UDF- FastB2B- ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR- INTx- Interrupt: pin A routed to IRQ 177 Region 0: I/O ports at 2400 [size=8] Region 1: I/O ports at 2000 [size=8] Kernel driver in use: serial ------ ttyS0, iobase: 0x03f8, irq: 4 (mainboard) ttyS1, iobase: 0x2400, irq: 177 (Card I/O) ttyS2, iobase: 0x2000, irq: 177 (Card I/O) ------ baycom_ser_fdx: version 0.10 compiled hdlcdrv: version 0.8 compiled
POL: Może ktoś mi powie dlaczego na ttyS0 działa idealnie a na karcie I/O tylko odbiera .... Gdzie mam błąd. Może w baycom_ser_fdx.c ??? ENG: Can someone tell me why the ttyS0 works perfectly and on the I/O only .... Where do I receive an error. Maybe baycom_ser_fdx.c???