I get all the way to the section where it says I need to run 'sudo ./findpass.sh', and it gives me output of 'Tunnel Socket: Setting SO_BINDTODEVICE: No suck device'.
The instructions I am following are at: http://wiki.ampr.org/wiki/Ubuntu_Linux_Gateway_Example#Setting_up_the_Tunnel... And I am to the section of ' Finding the password for AMPR-RIPD"
The only section that had an issue during this process is the isc-dhcp-server will not start. I don't believe this should make any difference, other than if I have a client on my Ham Network that needs DHCP, but I plan to statically assign those devices.. so I believe that point should be moot.
My installation is Ubuntu 14.04.4 LTS I only have 2 interface.. eth0 (outside WAN address from ISP. One of my /29 allocations) and eth1 (inside 192.168.44.0/24)
I know enough to make my way around, but am not normally a linux guy!! Let me know what other info would be helpful to share out, so we can get this one going.
Thanks guys!!
Rod,
You need the initial tunnel to ucsd up and running to find the password. So make sure to have something like:
'ip tunnel add ampr0 mode ipip ttl 64 local <your external ip here>'
sucessfully set up BEFORE running that findpass script... So you need to see in your case 3 interfaces, the 2 ethernet devices AND a IPIP tunnel interface.
Marius, YO2LOJ
-----Original Message----- From: Rod Ekholm Sent: Thursday, June 02, 2016 09:31 To: AMPRNet working group Subject: Re: [44net] OVA for ESXi?
(Please trim inclusions from previous messages) _______________________________________________ I get all the way to the section where it says I need to run 'sudo ./findpass.sh', and it gives me output of 'Tunnel Socket: Setting SO_BINDTODEVICE: No suck device'.
The instructions I am following are at: http://wiki.ampr.org/wiki/Ubuntu_Linux_Gateway_Example#Setting_up_the_Tunnel... And I am to the section of ' Finding the password for AMPR-RIPD"
The only section that had an issue during this process is the isc-dhcp-server will not start. I don't believe this should make any difference, other than if I have a client on my Ham Network that needs DHCP, but I plan to statically assign those devices.. so I believe that point should be moot.
My installation is Ubuntu 14.04.4 LTS I only have 2 interface.. eth0 (outside WAN address from ISP. One of my /29 allocations) and eth1 (inside 192.168.44.0/24)
I know enough to make my way around, but am not normally a linux guy!! Let me know what other info would be helpful to share out, so we can get this one going.
Thanks guys!!
-
Marius Petrescu -
Rod Ekholm