I'm trying to follow the instructions on https://wiki.ampr.org/wiki/Installing_ampr-ripd_on_a_Ubiquiti_EdgeRouter_or_... but I'm not getting it and I've reset back to the default settings. I've got the router setup and working as a gateway with external IP of 75.158.135.117 which was given by DHCP from my ISP and is on eth0. On eth1 is set as my internal network as 192.168.1.1/24. I have two ethernet adapters on my computer. One is going to eth1 on the router. The other is on eth2 on the router which is currently not configured. I was thinking eth2 would be my 44 net. I have setup a DMZ so everything that comes in to eth0 goes to my computer (I have a lot of servers running on that machine so if you scan it you will get lots of hits. Have fun until I lock it down).
I'm hitting a snag on the very first part of router prep. Where it says to edit the WAN_LOCAL rule set. Under which do I add these? Under source NAT rule or destination NAT rule?
BTW I'm running ER3 Lite 1.10.11 on my router. Once I figure out a few of these things I can take some snap shots of my setup to add to the wiki page to help future setups.
Stephen Atkins VE6CPU/VE6STA/VE6SU
Sent with [Proton Mail](https://proton.me/) secure email.
The ruleset is under Firewall/NAT in the Firewall Policies tab. I also updated the wiki page to specify this detail.
Marius, YO2LOJ
On 17/10/2022 18:24, Stephen Atkins via 44net wrote:
I'm trying to follow the instructions on https://wiki.ampr.org/wiki/Installing_ampr-ripd_on_a_Ubiquiti_EdgeRouter_or_... but I'm not getting it and I've reset back to the default settings. I've got the router setup and working as a gateway with external IP of 75.158.135.117 which was given by DHCP from my ISP and is on eth0. On eth1 is set as my internal network as 192.168.1.1/24. I have two ethernet adapters on my computer. One is going to eth1 on the router. The other is on eth2 on the router which is currently not configured. I was thinking eth2 would be my 44 net. I have setup a DMZ so everything that comes in to eth0 goes to my computer (I have a lot of servers running on that machine so if you scan it you will get lots of hits. Have fun until I lock it down).
I'm hitting a snag on the very first part of router prep. Where it says to edit the WAN_LOCAL rule set. Under which do I add these? Under source NAT rule or destination NAT rule?
BTW I'm running ER3 Lite 1.10.11 on my router. Once I figure out a few of these things I can take some snap shots of my setup to add to the wiki page to help future setups.
Stephen Atkins VE6CPU/VE6STA/VE6SU
Sent with Proton Mail https://proton.me/ secure email.
44net mailing list --44net@mailman.ampr.org To unsubscribe send an email to44net-leave@mailman.ampr.org
-
Marius Petrescu -
Stephen Atkins